What Speed Should A Bandsaw Run At?

What Speed Should A Bandsaw Run At?

A typical speed for the bandsaw is around 1,000 feet each moment. Wood can successfully be cut at a lot higher rates, up to more than 5,000 feet each moment, yet you ought to keep it slow in light of the fact that it’s more secure. Slower speeds for harder materials

Wood

A typical speed for the bandsaw is around 1,000 feet each moment. Wood can really be cut at a lot higher velocities, up to more than 5,000 feet each moment, yet you ought to keep it slow on the grounds that it’s more secure. A blade running at 5,000 feet each moment is fit for taking off at least one finger with the smallest of mistakes.

Aluminum

1,000 feet each moment is likewise an excellent bandsaw speed for cutting aluminum. It will give pleasant, neat, and tidy, and the cut will continue along at an entirely satisfactory rate.

Steel

To cut steel, you’ll have to run the bandsaw at a lot slower speed – – around 100 feet each moment. A machine running at this speed could seem as though it’s running too slowly, however running it any quicker nearly ensures that you’ll harm the blade. You’ll really warm up the tips of the teeth to the place where they relax and nearly soften away; they’re scraped away by the steel and the blade will then as of now not cut. This is the motivation behind why numerous models are worked out of aluminum rather than steel.

Brass

Brass is a typical material to use for bushings and other little-accuracy parts. This material ought to be cut at generally the very bandsaw speeds that you’d cut steel, conceivably somewhat higher.

Plastics

In light of the variety in the material properties of plastics, you will either have to look into a producer’s information sheet to learn legitimate cutting paces or simply try a bit. Nylon, since it’s moderately adaptable, can be cut at a large number of velocities and get an entirely OK cut.

Materials, for example, acrylic, which is extremely fragile, can have issues at both high and low rates. Check out the image above. This piece was cut at two paces: one section was cut at low speed and on second thought of cutting without a hitch, the teeth worked on the piece, leaving an unpleasant completion. The remainder of the cut was finished at high velocity, and there is another issue: the blade is warming up the material enough to really make it melt.

Read more about How To Speed Up A Bandsaw?